Connect To The Top Battery Terminal - Honeywell A700 Hardware Reference Manual

4. Install heat shrink tubing on the battery cable jacket.
5. Insert and secure the fuse in the fuse holder assembly.
6. Assemble the negative wire:
a. Strip 0.60 cm (0.25 in) of insulation from the green and white wires.
b. Twist the wires together.
c. Crimp a 3/8-inch terminal ring onto the wires.
7. Assemble the positive wire:
a. Cut a strip of red wire that is 5.08 cm (2 in) long.
b. Strip 0.60 cm (0.25 in) of insulation from the red and black wires.
c. Twist the wires together.
d. Crimp the fuse block assembly to the wires.
e. Crimp the red wire you cut to the other end of the fuse block assembly.
8. Install heat shrink tubing on the braided ground wire.
9. Crimp a 3/8-inch terminal ring onto the braided ground wire.
10. Connect the 4-pin connector to the power supply.

Connect to the Top Battery Terminal

The procedure you use to connect to the vehicle battery depends on the location of the battery
terminal: Top or Side.
CAUTION
Verify that the cable to battery connections are correct. Electrical energy from vehicle
batteries can harm equipment and people.
Voice Device and Headset Hardware Reference Guide 90