Configure Task And Voiceconsole; Scanner As Initiator; Configure Sr61 Scanner - Honeywell A700 Hardware Reference Manual

4. After installing EasySet, start the program and select your scanner model.
5. Generate a restore factory settings bar code by selecting 2. Reset all parameters > Reset
factory defaults .
6. Scan the bar code, either from onscreen or print the bar code.
7. If using security:
a. Use EasySet to generate a security enabled bar code by selecting 3. Interface >
Bluetooth > Security > Enable.
b. Scan the bar code.
c. Optional: generate and scan a bar code to set a custom pin by selecting 3. Interface >
Bluetooth > Security> Compose PIN:.

Configure task and VoiceConsole

1. Set the following advanced parameter in Task config
barcodeport = bt_scan
2. Turn on Bluetooth on the Talkman device.
3. View the properties of the Talkman device and ensure Bluetooth is enabled. If it is not
enabled, click Edit this device and set Bluetooth Enabled to "enabled".
4. Select Pair this device with a peripheral.
5. For Pairing type select "Bluetooth Scanner".
6. For Connection Mode select "Device initiates connection with peripheral".
7. In the Bluetooth Address field enter the Bluetooth MAC address of the scanner. This 12-
character ID is labeled "MAC ID" or "BDA" and is found on a label on the scanner.
8. Set Security to "Enabled" or "Disabled" as desired.
9. If using security, set Security Key to "0000" or the PIN entered when generating the custom
PIN bar code.
10. Click Pair with peripheral to initiate pairing.

Scanner as Initiator

Configure SR61 Scanner

To use this scanner with a Talkman device, you need to generate and scan configuration bar
codes:
1. Install the following on your PC:
EasySet (to generate configuration bar codes for the scanner), download from
l
Software > Barcode Scanners > Printer Drivers > Intermec Windows driver using the
link below
This can be downloaded from the Honeywell Technical Support Downloads portal:
https://hsmftp.honeywell.com.
2. You must have an account to download software. Create an account if you don't already
have one.
3. If you have not previously installed the Honeywell Download Manager, you must download
and install it before downloading EasySet.
4. After installing EasySet, start the program and select your scanner model.
5. Generate a restore factory settings bar code by selecting 2. Reset all parameters > Reset
factory defaults .
6. Scan the bar code, either from onscreen or print the bar code.
Voice Device and Headset Hardware Reference Guide 182