Attaching The Srx2/Srx3 To A Hard Hat - Honeywell A700 Hardware Reference Manual

Align the tab of the clip to fit into the slot.
l
Slide the clip into the slot until the tab clicks in place and it is firmly seated.
l
Mounting a brim-mount clip on a hard hat
l
Loosen the screws that secure the two clip brackets to the clip.
l
For large brim hats, it may be necessary to remove the brackets completely in order
to fit them over the brim without the clip in place.
From the under side of the hat, slide the brackets over the brim. If the brackets were
l
removed, slide the bracket ends back under the screws in the clip.
Position the clip on the outside of the hard hat, centered on the side of the hat.
l
Tighten the screws to secure the bracket and clip to the hard hat.
l
Removing a clip from a hard hat
l
For a slotted-mount clip, push the end of the spring arms from under the brim in
l
until they fit back through the slot. It may be necessary to use a tool to pry the arms
from their installed position.
For a brim-mount clip, loosen the bracket screws and slide the brackets and clip off
l
the hard hat.

Attaching the SRX2/SRX3 to a Hard Hat

With an SRX2/SRX3 Hard-Hat Headset clip mounted on the side of a hard hat, the headset's fork
and disk assembly snaps securely onto the hat.
Voice Device and Headset Hardware Reference Guide 114