Honeywell A700 Hardware Reference Manual page 149

the device is sleeping (not running a task)
l
a wired headset is not attached or a wireless headset is not actively connected to the device
l
the parameter SRXHeadsetEnable is set to 1 (Enabled), the default
l
the parameter SrxAutoPairEnable is set to 0 (Disabled), the default
l
For best performance when using an SRX2/SRX3 headset with a Talkman A700/A700x device,
use the latest SRX2/SRX3 software version. Obtain the latest headset software from your
Honeywell portal or reseller and use the Honeywell Accessory Update Utility to upgrade your
SRX2/SRX3 headset.
NOTE
Data sent through near field communication (NFC) is not encrypted nor does it follow any
specific safety protocol. This is because the transfer occurs over such a short range that it is
extremely unlikely that the data could be intercepted.
1. Turn on the SRX2/SRX3 headset.
2. If the headset's LED is blinking blue, it is currently paired to a device. Clear the pairing by
pressing the + and - buttons simultaneously on the SRX2/SRX3 headset.
3. If you are sharing headsets at your site:
You must first obtain the operator ID by reading the headband:
Touch area of the SRX2/SRX3 t-bar (headband) with the
l
raised oval on the side of the device with the
indicator blinks green. This associates the operator's headband to the device enabling
VoiceConsole to recognize the operator.
Touch the side of the A700/A700x device that has the
l
the SRX2/SRX3's keypad section together, aligning the ovals on each and holding
them together steadily, until the device state (ring) indicator blinks green. Note that
there is a 30-second timeout after a headband is recognized in step one. You must
pair the electronics module within 30 seconds from associating the headband for full
127
symbol, until the device state (ring)
Voice Device and Headset Hardware Reference Guide
symbol to center of the
symbol and the oval area of