Procedure: Verify Successful Turn-Up Of Xtc Cards; Procedure: Verify Successful Turn-Up Of High-Speed Cards; Card Software Installation - Cisco ONS 15327 User Documentation
Hide thumbs
Also See for ONS 15327:
- Procedure manual (478 pages) ,
- Manual (42 pages) ,
- Reference manual (166 pages)
Table of Contents
Advertisement
Card Installation and Turn-Up
Procedure: Verify Successful Turn-Up of XTC Cards
Install an XTC in Slot 6.
Step 1
Slot 6 is the working XTC slot.
Verify that the red FAIL LED blinks for approximately 30 seconds.
Step 2
Verify that all LEDs blink once and turn off.
Step 3
Verify the ACT/STBY LED is green (active).
Step 4
Step 5
Install the second XTC in Slot 5.
Slot 5 is the protect XTC slot.
After the LED boot sequence (Steps 3 and 4), verify that the ACT/STBY LED is yellow. The yellow LED
Step 6
indicates that the second XTC is the standby XTC.
Press the LAMP TEST button on the faceplate of each XTC and verify that all LEDs illuminate while
Step 7
you press the button.
Step 8
Verify that the card appears in the correct slot on the CTC node view screen.
Verify that the card is white on the CTC node view screen.
Step 9
Refer to
Procedure: Verify Successful Turn-Up of High-Speed Cards
Install a high speed card in Slots 1–4.
Step 1
Verify that the red FAIL LED turns on and remains lit for 20 to 30 seconds.
Step 2
Step 3
Verify that the red FAIL LED blinks for 30 to 45 seconds.
Verify that all LEDs blink once and turn off for 5 to 10 seconds.
Step 4
Step 5
Verify the ACT LED turns on.
Step 6
Verify that the card appears in the correct slot on the CTC node view screen.
Warning
Install blank faceplates into empty card slots. Blank faceplates serve three functions: They prevent
exposure to hazardous voltages and currents inside the ONS 15327 chassis, they eliminate
electromagnetic interference (EMI) that might disrupt other equipment, and they direct the flow of
cooling air through the chassis. Do not operate the system unless all cards and faceplates are in
place.
1.8.3 Card Software Installation
After you install an ONS 15327 card in a valid card slot, the card's software automatically updates to the
version that operates correctly with the software installed on the XTC. To verify the current version of
software installed on the XTC, click Help and then click About CTC. Refer to
Installation"
Cisco ONS 15327 User Documentation, R3.3
1-20
Chapter 2, "Software Installation"
for more information about using CTC.
for more information about using CTC.
Chapter 1
Hardware Installation
Chapter 2, "Software
June 2002
Advertisement
Table of Contents
