Table 2-6 Set Up Windows Pc For Craft Ons 15327 Connections Using Dhcp - Cisco ONS 15327 User Documentation

Running the CTC Installation Wizard
Procedure: Set Up a Windows PC for Craft Connection to an ONS 15327 Using DHCP
Use this procedure to set up your computer for craft connection to the ONS 15327 using DHCP (dynamic
host configuration protocol).
You will not be able to connect to the ONS 15327 if DHCP forwarding is not enabled on the ONS 15327
Caution
or the ONS 15327 is not connected to a DHCP server. By default, DHCP forwarding is not enabled. If
you are connecting to an ONS 15327 to perform initial shelf turnup, complete the
PC for Craft Connection to an ONS 15327 on the Same Subnet Using Static IP Addresses" procedure on
page 2-11
Detection" procedure on page
Verify the operating system that is installed on your computer:
Step 1
a.
b.
c.
Complete the steps in
Step 2
Table 2-6 Set Up Windows PC for Craft ONS 15327 Connections Using DHCP
For Windows 95/98:
1. From the Windows Start menu,
choose Settings > Control Panel.
On the Control Panel dialog box,
2.
click the Network icon.
In the Network dialog box select
3.
TCP/IP for your PC Ethernet card,
then click Properties.
4. On the TCP/IP Properties dialog
box, click the DNS Configuration
tab and choose Disable DNS.
5. Click the WINS Configuration tab
and choose Disable WINS
Resolution.
Click the IP Address tab.
6.
In the IP Address window, click
7.
Obtain an IP address from a
DHCP Server.
Click OK.
8.
When the prompt to restart your PC
9.
displays, click Yes.
Cisco ONS 15327 User Documentation
2-14
or the "Set Up a Windows PC for Craft Connection to an ONS 15327 Using Automatic Host
From the Windows Start menu, choose Settings > Control Panel.
On the Control Panel window, double-click the System icon.
On the General tab of the System Settings window, verify that the Windows operating system is one
of the following: Windows 95, Windows 98, Windows 2000, or Windows NT 4.0
Table 2-6
For Windows NT:
1. From the Windows Start menu,
choose Settings > Control Panel.
On the Control Panel dialog box,
2.
click the Network icon.
In the Network dialog box click the
3.
Protocols tab, choose TCP/IP
Protocol, then click Properties.
4. Click the IP Address tab.
In the IP Address window, click
5.
Obtain an IP address from a
DHCP Server.
Click OK.
6.
7. Click Apply.
8. If Windows prompts you to restart
your PC, click Yes.
2-15.
for the operating system installed on your PC.
Chapter 2 Software Installation
"Set Up a Windows
For Windows 2000:
1. From the Windows Start menu,
choose Settings > Network and
Dial-up Connections > Local Area
Connection.
On the Local Area Connection
2.
Status dialog box, click Properties.
On the General tab, choose Internet
3.
Protocol (TCP/IP), then click
Properties.
Click Obtain an IP address from a
4.
DHCP Server.
Click OK.
5.
On the Local Area Connection
6.
Status dialog box, click Close.
On the Local Area Connection
7.
Properties dialog box, click OK.
June 2002