Network View Tasks; Table 2-12 Performing Network Management Tasks In Network View - Cisco ONS 15327 User Documentation
Hide thumbs
Also See for ONS 15327:
- Procedure manual (478 pages) ,
- Manual (42 pages) ,
- Reference manual (166 pages)
Table of Contents
Advertisement
Working with the CTC Window
2.6.2.2 Network View Tasks
Right-click the network view graphic area or a node, span, or domain (domains are described in the
"Creating Domains" section on page
are available from the network view.
Table 2-12 Performing Network Management Tasks in Network View
Action
Open a node
Move a node icon
Reset node icon
position
Provision a circuit
Update circuits with
new node
Display a link end
point
Display span
properties
Perform a UPSR
protection switch for
an entire span
Upgrade a span
Cisco ONS 15327 User Documentation
2-32
2-33) to display shortcut menus.
Procedure
Any of the following:
Double-click a node icon
•
Right-click a node icon and choose Open Node from the shortcut menu
•
Click a node and choose Go to Selected Object View from the CTC View
•
menu
From the View menu choose Go to Other Node. Select a node from the
•
Select Node dialog box
Double-click a node alarm or event in the Alarms or History tabs
•
Press the Ctrl key and the left mouse button simultaneously and drag the node
icon to a new location.
Right-click a node and choose Reset Node Position from the shortcut menu.
The node icon moves to the position defined by the longitude and latitude fields
on the Provisioning > General tabs in node view.
Right-click a node. From the shortcut menu, choose Provision Circuit To and
select the node where you want to provision the circuit. For circuit creation
procedures, see the
"Create an Automatically Routed Circuit" procedure on
page
6-2.
Right-click a node and choose Update Circuits With New Node from the
shortcut menu. Use this command when you add a new node and want to pass
circuits through it.
Right-click a span. On the shortcut menu, select Go To [node/slot/port] for the
drop port you want to view. CTC displays the card in card view.
Any of the following:
Move the mouse over a span; properties display near the span
•
•
Click a span; properties display in the upper left corner of the window
Right-click a span; properties display at the top of the shortcut menu
•
Right-click a network span and click Circuits. See the
procedure on page 5-25
for UPSR protection switch procedures.
Right-click a span and choose Upgrade Span from the shortcut menu.
Chapter 2
Software Installation
Table 2-12
lists the actions that
"Switch UPSR Traffic"
June 2002
Advertisement
Table of Contents
