Cisco ONS 15327 User Documentation page 99

Hide thumbs Also See for ONS 15327:
Table of Contents

Advertisement

Chapter 2
Software Installation
Procedure: Set up a Solaris Workstation for Craft Connection to an ONS 15327
Use this procedure to connect your workstation directly to the ONS 15327.
Note
This procedure employs the ONS 15327 automatic host detection to allow you to directly connect to
multiple ONS 15327s successively without reconfiguring your workstation's IP address. However, if
proxy server is not enabled on the ONS 15327, DCC-connected nodes on different subnets will not be
visible.
Choose a cable connection method:
Step 1
Log into the workstation as the root user.
Step 2
Step 3
Check to see if the interface is plumbed by typing:
a.
b.
Step 4
Configure the IP address on the interface by typing:
For example: #ifconfig hme0 10.20.30.40 netmask 255.255.255.0 up
Note
Test the connection:
Step 5
a.
b.
June 2002
RJ-45 jack on the ONS 15327 XTC: Attach a CAT-5 cable from the workstation's NIC card to the
RJ-45 jack on the ONS 15327 XTC.
Hub or switch: Attach a CAT-5 cable from the workstation's NIC card to the RJ-45 jack on a hub
or switch to which the ONS 15327 is physically connected.
# ifconfig <device>
For example: # ifconfig hme1
If the interface is plumbed, a message similar to the following appears:
hme1:flags=1000842<BROADCAST,RUNNING,MULTICAST,IPv4>mtu 1500 index 2 inet 0.0.0.0
netmask 0. Go to Step 4.
If the interface is not plumbed, a message similar to the following appears: ifconfig: status:
SIOCGLIFFLAGS: hme1: no such interface. Plumb the interface by typing:
# if config <device> plumb
For example: ifconfig hme1 plumb
#ifconfig <interface> <ip address> netmask <netmask> up
Enter an IP address that is identical to the ONS 15327 IP address except for the last three
digits. The last three digits must be between 1 and 254. In the Subnet Mask field, type
255.255.255.0.
Start Netscape Navigator or Internet Explorer.
Enter the Cisco ONS 15327 IP address in the web address (URL) field. If the connection is
established, a Java Console window, CTC caching messages, and the Cisco Transport Controller
Login dialog box display. If this occurs, go to Step 2 of the
page 2-24
to complete the login. If the Login dialog box does not appear, complete Steps c and d.
Running the CTC Installation Wizard
"Log into the ONS 15327" procedure on
Cisco ONS 15327 User Documentation
2-17

Advertisement

Table of Contents
loading

Table of Contents