Figure 9-16 Creating An Ethernet Circuit - Cisco ONS 15327 User Documentation

Chapter 9 Ethernet Operation
Procedure: Provision a Single-card EtherSwitch Manual Cross-Connect
Display CTC for one of the ONS 15327 Ethernet circuit endpoints.
Step 1
Double-click one of the Ethernet cards that will carry the circuit.
Step 2
Click the Provisioning > Card tabs.
Step 3
Under Card Mode, verify that Single-card EtherSwitch is checked.
Step 4
If the Single-card EtherSwitch is not checked, check it and click Apply.
Step 5 Display the node view.
Click the Circuits tab and click Create.
Step 6
The Circuit Creation (Circuit Attributes) dialog box appears

Figure 9-16 Creating an Ethernet circuit

In the Name field, type a name for the circuit.
Step 7
Step 8 From the Type pull-down menu, choose STS.
Note
Choose the size of the circuit from the Size pull-down menu.
Step 9
The valid circuit sizes for an Ethernet Single-card circuit are STS-1, STS-3c, STS-6c and 12c.
Verify that the Bidirectional check box is checked and click Next.
Step 10
The Circuit Creation (Circuit Source) dialog box appears.
From the Node menu, choose the current node as the circuit source.
Step 11
Step 12 From the Slot menu, choose the Ethernet card that will carry the circuit and click Next.
The Circuit Creation (Circuit Destination) dialog box appears.
From the Node menu, choose the current node as the circuit destination.
Step 13
Step 14 From the Slot menu, choose the optical card that will carry the circuit.
Choose the STS that will carry the circuit from the STS menu and click Next.
Step 15
Note
The Circuit Creation (Circuit VLAN Selection) dialog box appears
June 2002
The types VT and VT Tunnel do not apply to Ethernet circuits.
For Ethernet manual cross-connects, the same node serves as both source and destination.
Ethernet Circuit Configurations
(Figure 9-16).
(Figure 9-10 on page
Cisco ONS 15327 User Documentation, R3.3
9-9).
9-17