Figure 9-13 Viewing A Span - Cisco ONS 15327 User Documentation

Hide thumbs Also See for ONS 15327:

Table of Contents

Ethernet Operation

Figure 9-13 Viewing a span

Verify that the new circuit is correctly configured.

Click Finish.

You now need to provision the Ethernet ports and assign ports to VLANs. For port provisioning

instructions, see the

assigning ports to VLANs, see the

9.4.3 Hub and Spoke Ethernet Circuit Provisioning

This section provides steps for creating a hub and spoke Ethernet circuit configuration. The hub and

spoke configuration connects point-to-point circuits (the spokes) to an aggregation point (the hub). In

many cases, the hub links to a high-speed connection and the spokes are Ethernet cards.

illustrates a sample hub and spoke ring. Your network architecture may differ from the example.

If the circuit information is not correct, click the Back button and repeat the procedure with the

correct information. You can also click Finish, delete the completed circuit, and begin the

procedure again.

"Provision E10/100-4 Ethernet Ports" procedure on page

"Provision Ethernet Ports for VLAN Membership" procedure on

Cisco ONS 15327 User Documentation, R3.3

Ethernet Circuit Configurations

9-3. For instructions about