Chapter 1
Hardware Installation
Insert the return (black) wire into the right hand (RTN) slot of the connector.
Step 8
cable being inserted into the MIC power connector.
Figure 1-8
Step 9
Replace the cable fastening screw for the return (RTN) wire and tighten with a small slot head
screwdriver.
Step 10
Insert the battery (red) wire into the left hand (-48V) slot of the connector.
Replace the cable fastening screw for the battery (-48V) wire and tighten with the screwdriver.
Step 11
Insert the connector back into the slot on the MIC and tighten the screws with the screwdriver.
Step 12
shows the MIC power connector being installed.
June 2002
Inserting a power cable into the MIC power connector
Power and Ground Installation
Figure 1-8
Cisco ONS 15327 User Documentation, R3.3
shows a power
Figure 1-9
1-13