Figure 1-7 Removing The Mic Power Connector - Cisco ONS 15327 User Documentation

Power and Ground Installation
When installing the node, the ground connection must always be made first and disconnected last.
Warning
Strip .22 inches of insulation from all power cables that you connect to the ONS 15327 power
Step 4
connectors.
Install MICs in Slots 7 and 8.
Step 5
See the
Do not expose more than .22 inches of bare wire on power cables.
Warning
Before you make any crimp connections, coat all bare conductors (battery, battery return, and frame
Caution
ground) with an appropriate antioxidant compound. Bring all unplated connectors, braided strap, and bus
bars to a bright finish, then coat with an antioxidant before you connect them. You do not need to prepare
tinned, solder-plated, or silver-plated connectors and other plated connection surfaces in this manner, but
always keep them clean and free of contaminants.
Remove the connector from the slot by grasping it with your fingers and gently pulling it. If you cannot
Step 6
remove it easily, you can use a pair of needle nose pliers and grab it by the center of the channel.
Figure 1-7
Figure 1-7
Remove the cable fastening screws (the screws on the top of the connector that become visible when
Step 7
the connector is removed).
Cisco ONS 15327 User Documentation, R3.3
1-12
"Card Installation and Turn-Up" section on page 1-16
shows the MIC power connector being removed.
Removing the MIC power connector
-4 8 V
P W R A
for installation in instructions.
R T N
Chapter 1 Hardware Installation
June 2002