Ts-Sh; Installation Screws - Yamaha TS-S User Manual

1.1.2
Use the mounting screw holes to install the controller on a vertical wall in the manner shown below or use the
rear groove and claw to install it on a DIN rail.
When using the mounting screw holes, it is necessary to remove the controller top cover before starting the
installation.
n
NOTE
Reattach the cover in place after installed.
2
When installing the controller on a DIN rail, hang the upper groove on the DIN rail and push the lower claw
into the DIN rail to secure the controller.
n
NOTE
After installed, make sure that the controller is secured to the DIN rail firmly. If not secured to the DIN rail firmly, this
may cause the controller to break or drop.
1.1.3 Installation screws
Use the following screw type for installation.
Controller Model
TS-X, TS-P
TS-S, TS-S2

TS-SH

2-2
TS-SH
Installation of controller main body
Using the mounting screw holes
* Remove the controller top cover before
starting the work.
After installed, reattach the cover in place.
Mounting Area Thickness
4mm
5mm
6mm
Installing the controller on a DIN rail
1
2
1. Hang the upper groove on a DIN rail.
2. Push the lower claw into the DIN rail to secure
the controller.
Hole Dia. Recommended Screw
φ 5.4 M5
φ 4.5 M4
φ 4.5
M4
23201-M5-00
Recommended Tightening Torque
1.5 N·m
0.5 N·m
0.5 N·m