Cylinder Head Cover Installation - Honda Civic Service Manual

Cylinder Head Installation
Install the cylinder head in the reverse order of
removat:
1. Clean the cylinder head and block surface.
2. Install the new cylinder head gasket (A) anddowel
pins (B) on the cylinder block. Always use a new
cylinder head gasket.
Set the crankshaft to top dead center {TDC). Align
the TDC mark (A) on the crankshaft sprocket with
the pointer (B) on the cylinder block.
4. Install the cylinder head on the block.
5. Measure the diameter of each cylinder head bolt at
ooint A and Doint B.
a 50 mm (2.0 in.l
f.f
)>-
A '15 mm {'1.8 in.)
" < > .
l f e i t h e r d i a m e t e r i s l e s s t h a n 1 0 . 6 m m { 0 . 4 2 i n . ) ,
replace the cvlinder head bolt.
( c o n t d )
6-39