Cylinder Head Installation - Honda Accord 2008 Manual

07/11/02 09:23:55 61TA0000_060_0046
Cylinder Head

Cylinder Head Installation

1. Install a new coolant separator in the engine block
whenever the engine block is replaced.
＊０１
2. Clean the cylinder head and engine block surface.
3. Install the new cylinder head gasket (A) and dowel
pins (B) on the engine block. Always use a new
cylinder head gasket.
＊０２
B
6-46
4. Set the crankshaft to top dead center (TDC). Align
the TDC mark (A) on the crankshaft sprocket with
the pointer (B) on the engine block.
B
A
5. Install the cylinder head on the engine block.
6. Measure the diameter of each cylinder head bolt at
point A and point B.
A
B
7. If either diameter is less than 10.6 mm (0.42 in.),
replace the cylinder head bolt.
ＴＡ０８ＡＥＩＡ１４６００００００００ＫＣＡＴ００
50 mm (2.0 in.)
45 mm (1.8 in.)
B A
＊０３
＊０４