Vrrp Critical-Ip - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

vrrp critical-ip

vrrp VRID critical-ip IP-ADDRESS
no vrrp VRID critical-ip
Syntax Description
VRID
IP-ADDRESS
Default
Command Mode
Usage Guideline
CLI Reference Guide
Use this command to configure the critical IP address. To remove the critical IP
address using the no form of this command.
Specifies the Virtual router identifier, which is the number identifying the virtual
router for which the critical IP address is being configured.
The virtual router identifier is configured with the command "vrrp ip" on
page 917.
Range is from 1 to 255.
Specifies the IP address of the neighbor router that provide the most direct route
to the Internet.
Not configured
Interface configuration
Referring to the figure below, Router-1 is the VRRP master router while Router-2
is the backup router for virtual IP 20.1.1.5. For the master router, the next hop
router which provides access to the Interface is Router-X and the interface IP
address on Router-X that connects to Router-1 is 60.5.1.1. IP address 60.5.1.1 is
the critical IP address for the master router.
Configure the critical IP address on the master router and the master router will
monitor the ARP cache of the critical IP address. Once the ARP cache of critical
IP is gone from the ARP table, the master router will give up its master status.
vrrp critical-ip
915