Banner Login - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604

banner login

AB
banner login LINE
default banner login
Syntax Description
LINE
Default
Command Mode
Usage Guideline
CLI Reference Guide
Use banner login to enter the banner login mode in order to configure the
banner login message. Use the default form of the command to set the login
banner to factory default.
A displaced string and spaces are allowed. The maximum length is 320
characters. In addition, two special character sequences are used; '/n' is used as
new line and '/r ' is used as a carriage return. Please refer to the usage guideline
for more detail.
Project dependent
Sample Banner Login Message:
DGS-6604 Chassis Ethernet Switch
Command Line Interface,
Firmware: Build 1.00.027
Copyright (c) 2011 D-Link Corporation, all rights reserved.
Where 2011 represents the year for release of the new firmware. It should be
updated if needed by the subsequent release of the firmware.
Global configuration
Use this command to define a customized banner to be displayed before the user
is prompted for their username and password. Enter the banner login command
followed by a desired display string and then execute the command by pressing
ENTER to complete the modification.
When a multiple lines banner is needed, use special character sequences such
as '/n' which represents a new line and '/r ' which represents a carriage return.
However if '/n' or '/r' is required to be displayed as part of the string in the line,
then both '/n' and 'r' must be prefixed with another '/' as an escape sequence to
overide the special character sequence functionality, for example '//n', or '//r'.
At the end of each line is either a '/n' or '/r' . If more than 80 characters are
entered without an '/n' or '/r' ending the line, then the line will be truncated and
the first 80 characters are displayed.
banner login
57