Storm-Control Level (Interface) - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

storm-control level (Interface)

storm-control {broadcast | multicast | unicast} level {LEVEL | pps PPS}
no storm-control {broadcast | multicast | unicast} level
Syntax Description
Broadcast
Multicast
Unicast
level LEVEL
level pps PPS
Default
Command Mode
Usage Guideline
Examples
Switch# configure terminal
Switch(config)# interface eth3.1
Switch(config-if)# storm-control broadcast level pps 500
Switch# show storm-control interface broadcast
Interface Storm
-------------------------------------------------------------
eth3.1 Broadcast
CLI Reference Guide
This command configures the rising threshold for Storm Control function. Use no
command to return the default settings.
Set Broadcast rate limiting
Set Multicast rate limiting
Set Unicast(DLF) rate limiting
Specifies the rising threshold as a percentage (0 to 100) of total bandwidth of the
port.
Specifies the rising threshold as a rate in packets per second at which traffic is
received on the port. The range of PPS is from 1 to 148810 (for 100 Mbps). For
1000 Mbps, the range is 1 to 1488100 and so on.
level pps PPS: 131072 packets per second
Interface configuration
Only a physical port interface is valid for this command.
The precise suppression level, as a percentage (0 to 100) of total bandwidth of
specific port interface, is not able to be calculated exactly. That is, the current
calculation formula assumes that the packet size of all incoming packets is 1512
bytes.
This example shows how to configure Broadcast storm control LEVEL by pps
mode. It assigns the pps threshold level of interface eth3.1 for incoming
broadcast packets to 500 and drops the packets that exceed the threshold.
Action
Drop
Type
pps
storm-control level (Interface)
Threshold
500
862