Default Ipv6 Nd Prefix - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 mm

default ipv6 nd prefix

default ipv6 nd prefix X:X::X:X/M
Syntax Description
X:X::X:X/M
Default
Command Mode
Usage Guideline
Example
Switch > enable
Switch # configure terminal
Switch (config) # interface vlan1
Switch (config-if) # default ipv6 nd prefix 3ffe:501:ffff::/64
Switch (config-if) #
CLI Reference Guide
This command is used to default the IPv6 RA prefix information.
IPv6 network address. This argument must be in the form documented in
RFC2373 where the address is specified in hexadecimal using 16-bit value
between colons.
X:X::X:X: IPv6 address
M: IPv6 prefix length
None
VLAN interface configuration
RA prefix entry must be created first.
This example shows how to default the IPv6 nd prefix instance:
default ipv6 nd prefix
141