Set Ipv6 Next-Hop - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

set ipv6 next-hop

set ipv6 next-hop IPv6-ADDRESS
no set ipv6 next-hop [IPv6-ADDRESS]
Syntax Description
IPv6-ADDRESS
Default
Command Mode
Usage Guideline
Example
CLI Reference Guide
Use this command to set the next-hop to route the packets that pass a match
clause of a route map. Use the no command to remove the setting.
Specify the next hop to route the packet. The next hop must be an adjacent
router.
Not configured
Route-map configuration
If other set clauses for policy based routing are used with the command, they will
be evaluated based on the following ordering:
1. set ipv6 next-hop
2. set interface
3. set ipv6 default next-hop
4. set default interface
With this ordering, the set next-hop clauses and the set interface clauses will be
evaluated before look up of the routing table. If route cannot be found for the
packets, the set ip default next-hop and set default interface command will be
evaluated.
In the following example, PBR will change the next-hop setting when the source
ip is 2000::/16 and vlan is vlan100. We want to set next-hop of this route entry to
100::BEAE:C5FF:FE9A. The steps as follows:
At first, create an IP basic access list, named Strict-Control which permit prefix
2000::/16
Secondly, create a route map, named myPolicy which define a match rule to
associate ip address prefix-list to the previously created access list, Strict-
Control.
set ipv6 next-hop
546