Ipv6 Ospf Transmit Delay - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604

ipv6 ospf transmit delay

ipv6 ospf transmit-delay SECONDS [instance-id INSTANCE-ID]
no ipv6 ospf transmit-delay [instance-id INSTANCE-ID]
Syntax Description
SECONDS
INSTANCE-ID
Default
Command Mode
Usage Guideline
Example
Switch > enable
Switch # configure terminal
Switch (config) # interface vlan1
Switch (config-if)# ipv6 ospf transmit-delay 3
CLI Reference Guide
To set the estimated time required to send a link-state update packet on the
interface, use the ipv6 ospf transmit-delay command. To return to the default
value, use the no form of this command.
The interval the router waits before it transmits a packet. The valid setting is 1-
65535.
(Optional) Instance identifier. To change this ID, configure the "no" command
first. The valid setting is from 0 to 255.
SECONDS: 1
INSTANCE-ID: 0
Interface configuration
Before being transmited, Link-State Advertisements (LSAs) in the update packet
must have their ages incremented by the amount specified in the seconds. The
value assigned should take into account the transmission and propagation
delays for the interface.
If the delay is not added before transmission over a link, the time in which LSAs
propagate over the link will not be considered. This setting has more significance
on very low-speed links.
The following example sets the transmit delay value to 3 seconds.
ipv6 ospf transmit delay
347