D-Link DGS-6600-48T Cli Reference Manual page 518

DGS-6604 m
Examples
Switch(config)# router rip
Switch(config-router)# redistribute ospf
Switch(config-router)# end
Switch#
Switch(config)# router rip
Switch(config-router)# redistribute ospf metric 11
Switch(config-router)# end
Switch#
CLI Reference Guide
3. If the metric is specified as 0, the metric for the redistributed route from other
protocols to RIP will be 1.
If the default-metric is not specified, then the original metric from the
redistributed protocol will be transparently carried through.
1. The default-metric command cannot be used to affect the metric used to
advertise connected routes.
2. The metric value specified in the redistributed command supersedes the
metric value specified using the default-metric command.
This example shows OSPF routes are redistributed into a RIP domain:
The following example causes the specified OSPF routes to be redistributed into
an RIP domain. The OSPF-derived metric will be remapped to 11.
Verify the settings by entering the show ip protocols rip command.
redistribute (RIP)
508