D-Link DGS-6600-48T Cli Reference Manual page 369

DGS-6604 m
key
K
key KEY-ID
no key KEY-ID
Syntax Description
KEY-ID
Default
Command Mode
Usage Guideline
CLI Reference Guide
Use the key command to identify a key on a key chain used for routing protocol
authentication. Use the no key command to remove the key from the key chain.
The iIdentification number of an authentication key of a key chain. The available
range for the key ID is a number from 0 to 2147483647, up to 32 key IDs can be
configured. The key identification numbers need not be consecutive.
There are no keys configured on the key chain.
key-chain configuration
Only Routing Information Protocol (RIP) Version 2 uses key chains.
Using the key command will enter into the key-chain key configuration mode.
It is useful to have multiple keys on a key chain so that the software can
sequence through the keys as they become invalid over a period of time. This is
based on the accept-lifetime, send-lifetime and key chain key command
settings.
If the last key expires, authentication will be invalid.
If there was a discrepancy in the set time of the router's keys, the first valid key
will be chosen.
To remove all keys, remove the key chain with the no key chain command.
key
359