Default-Information Originate (Ipv6 Ospf) - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 mm

default-information originate (IPv6 OSPF)

default-information originate [always] [metric METRIC-VALUE] [metric-type TYPE-VALUE]
no default-information originate
Syntax Description
always
metric
METRIC-VALUE
metric-type
TYPE-VALUE
Default
Command Mode
Usage Guideline
Example
Switch > enable
Switch # configure terminal
Switch (config) # router ipv6 ospf
Switch(config-router)# default-information originate always
CLI Reference Guide
Use default-information originate to configure an IPv6 OSPF to generate a
default external route (type 0x4005 LSA). Use the no form of the command to
disable the originate type 0x4005 LSA default route.
(Optional) Always advertise the default route regardless whether a default route
exists in the configuration or not.
(Optional) If metric is not specified, the default metric is 1. The range off values
allowable for the OSPFv3 metric is from 0-16777214.
(Optional) IPv6 OSPF specifies the external link type associated with the default
route advertised into the IPv6 OSPF routing domain. It can be one of two values:
1: Type 1 external route
2: Type 2 external route
If a metric-type is not specified, the Switch adopts a Type 2 external route. This
is only for IPv6 OSPF.
None
Router configuration
The default-information originate command is used to configure a routing
process, in order to advertise a default route (prefix ::/0). When always is not
specified, the default route will only be advertised when the redistribution
statement is configured and the default route exists in the redistributed routes.
This example shows how to advertise the default route regardless whether a
default route exists in the configuration or not.
default-information originate (IPv6 OSPF)
138