Ipv6 Hop-Limit - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604

ipv6 hop-limit

ipv6 hop-limit <0-255>
no ipv6 hop-limit
Syntax Description
<0-255>
Default
Command Mode
Usage Guideline
Example
Switch > enable
Switch # configure terminal
Switch (config) # interface vlan1
Switch (config-if) # ipv6 hop-limit 255
Switch (config-if) #
CLI Reference Guide
This command is used to configure the IPv6 hop limit setting for an interface of
this switch. The no form of this command resets the IPv6 hop limit to the default
value.
The IPv6 hop limit range, "0" means not specified on this interface and to use the
default value to send a packet.
Hop limit: 64
VLAN interface configuration
The VLAN interface must be created first before this command can be used.
This example shows how to configure IPv6 hop limit setting:
ipv6 hop-limit
331