Match Ipv6 Address - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

match ipv6 address

match ipv6 address IPv6-ACCESS-LIST-NAME
no match ipv6 address [IPv6-ACCESS-LIST-NAME]
Syntax Description
IPv6-ACCESS-LIST-
NAME
Default
Command Mode
Usage Guideline
Example
Switch(config)# ipv6
Switch(config-ip-acl) # permit 2000::3:4 ffff::0 any
Switch(config-ip-acl)# exit
Switch(config)# route-map myPolicy permit 1
Switch(config-route-map)# match ipv6 address aclv6cfg
CLI Reference Guide
Use this command to define a clause to match the route based on IPv6 access
list.
Specify an IPv6 access list name.
Not configured
Route-map configuration
Use the match ipv6 address command in route map configure mode to define
rule for matching routes against IP standard access list.
The following example create an IP access list "aclv6cfg" first and create a route
map entry to match against the create IP access list.
access-list extended aclv6cfg
You can verify your settings by entering the show route map command.
match ipv6 address
412