DGS-6604
m
lldp tx-delay
lldp tx-delay SECONDS
no lldp tx-delay
Syntax Description
SECONDS
Default
Command Mode
Usage Guideline
Example
Switch(config)# lldp tx-delay 8
Switch(config)# no lldp tx-delay
CLI Reference Guide
To set the transmission delay timer use the lldp tx-delay command. This delay
timer defines the minimum interval between sending of LLDP messages due to
constantly change of MIB content. Use the no form of this command to return to
the default settings.
Specifies a delay for sending successive LLDPDU on an interface; valid values
are from 1 to 8192 seconds and should not greater than one-fourth of
transmission interval timer
2 seconds
Global configuration
The LLDP transmission interval (tx-interval) must be greater than or equal to four
times of transmission delay timer.
This example shows how to set the transmission delay timer to 8 seconds.
The following example configures the transmission delay timer to default value.
lldp tx-delay
385