Erpi Raps-Vlan - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

erpi raps-vlan

erpi INSTANCE-ID raps-vlan VLAN-ID
no erpi INSTANCE-ID raps-vlan
Syntax Description
INSTANCE-ID
VLAN-ID
Default
Command Mode
Usage Guideline
Example
Switch(config-erps-domain)# erpi 1 raps-vlan 2
Switch(config-erps-domain)#
Switch(config-erps-domain)# no erpi 1 raps-vlan
Switch(config-erps-domain)#
CLI Reference Guide
Use the erpi raps-vlan command to configure the R-APS controlled VLAN of an
ERP instance. Use the no form of this command to remove the R-APS controlled
VLAN setting.
Specifies the identifier of ERP instance. The valid range is 1 to 4095.
Specifies the VLAN ID of RAPS controlled VLAN for the ERP instance. The valid
range is 1 to 4094.
Not configured
ERPS domain configuration mode
Use the command to assign the R-APS controlled VLAN for the ERP instance.
The R-APS controlled VLAN need to be assigned before the ERP instance can
be enabled.
The specified R-APS VLAN does not need to exist to configure the command.
If user removes the R-APS controlled VLAN when the ERP instance is in
operation, the ERP instance will enter operational disabled state.
Different ERP instances can not use the same R-APS controlled VLAN.
The following example shows how to configure R-APS controlled VLAN to "2" of
ERP instance 1:
The following example shows how to remove R-APS controlled VLAN setting of
ERP instance 1:
erpi raps-vlan
186