Based-On Relay-Ip-Address - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604

based-on relay-ip-address

based-on relay-ip-address IP-ADDRESS
no based-on relay-ip-address IP-ADDRESS
Syntax Description
IP-ADDRESS
Default
Command Mode
Usage Guideline
Examples
switch(config)#ip dhcp pool pool1
switch(config-dhcp)#based-on relay-ip-address 10.1.1.254
CLI Reference Guide
This command is used to specify a rule for the DHCP address pool's only
response for BOOTP forwarder or relay. Use the no form of the command to
remove the rule from a DHCP address pool.
Specifies the IP address of BOOTP forwarder for relay.
None
DHCP pool configuration
An additional rule can be set for DHCP address pool for each relay IP address.
All of the DHCP IP address assignment rules take effect to the corresponding
DHCP address pool. All of the based-on commands will be combined using
logical AND operations with other rules set by all the other based-on commands.
The following example sets a rule used for IP address assignment (DHCP IP
address pool1) based on the Relay IP address.
based-on relay-ip-address
63