Show Ipv6 Neighbors - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

show ipv6 neighbors

show ipv6 neighbors
Default
Command Mode
Usage Guideline
Example
Switch > enable
Switch # show ipv6 neighbors
IPv6 Address
fe80::250:baff:fef9:b512
Switch #
Display Field
Descriptions
Display Field
Type
Status
CLI Reference Guide
This command is used to display the IPv6 neighbor information.
None
User EXEC or any configuration mode
None
The example shows how to display IPv6 neighbor information.
Description of significant display fields.
DYNM - Dynamic learning entry.
STATIC - Static neighbor entry (for example, user configuration)
LOCAL - Local interface entry.
REACH (Reachable) - Positive confirmation was received within the last
ReachableTime, in milliseconds, that the forward path to the neighbor was
properly functioning . While in the REACH state, the device takes no special
action as packets are sent.
STALE - More than the ReachableTime, in milliseconds, has elapsed since
the last positive confirmation was received that the forward path was properly
functioning. While in the STALE state, the device takes no action until a
packet is sent.
DELAY - More than ReachableTime, in milliseconds, has elapsed since the
last positive confirmation was received that the forward path was properly
functioning. A packet was sent within the last DELAY_FIRST_PROBE_TIME
seconds. If no reachability confirmation is received within the
DELAY_FIRST_PROBE_TIME in seconds of entering the DELAY state, send
a neighbor solicitation message and change the state to PROBE.
PROBE - A reachability confirmation is actively sought by resending neighbor
solicitation messages every RetransTimer, in milliseconds.
MAC Address
0050.baf9.b512
Description
show ipv6 neighbors
Interface Type
vlan1 DYNM
Status
STALE
689