Spanning-Tree Mst Priority - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

spanning-tree mst priority

spanning-tree mst INSTANCE-ID priority PRIORITY
no spanning-tree mst INSTANCE-ID priority
Syntax Description
INSTANCE-ID
PRIORITY
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)#spanning-tree mst 2 priority 0
Switch(config)# end
CLI Reference Guide
Use this command to configure the bridge priority value for the selected MSTP
instance. Use the no form of the command to return the setting to the default
setting.
Specifies the MSTP instance identifier. Valid values are from 0 to 63. The
number of supported MSTP instances is project dependent. Instance 0
represents the default instance, CIST.
Specifies the bridge priority. The priority value must be divisible by 4096 and the
range is from 0 to 61440.
PRIORITY: 32768
Global configuration
The number of supported MSTP instances is project dependent.
This priority has same definition as the "spanning-tree priority" on page 854
within the STP command set, but it can specify different priorities for each distinct
MSTP instance.
This example shows how to configure bridge priority for the MSTP instance 2.
Verify the settings by entering the show spanning-tree mst command.
spanning-tree mst priority
852