Neighbor Timers - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

neighbor timers

neighbor { IP-ADDRESS | PEER-GROUP-NAME} timers KEEP-ALIVE HOLD-TIME
no neighbor { IP-ADDRESS | PEER-GROUP-NAME} timers
Syntax Description
IP-ADDRESS
PEER-GROUP-NAME Name of a Border Gateway Protocol (BGP) peer group.
KEEP-ALIVE
HOLD-TIME
Default
Command Mode
Usage Guideline
Example
Switch(config)# router bgp 65100
Switch(config-router)# neighbor 172.16.10.10 timer 120 360
CLI Reference Guide
Use this command to set the timers for a specific BGP peer or peer group. Use
the no form of this command to clear the timers for a specific BGP neighbor.
Specifies IP address prefixes.
The frequency (in seconds) that specifies how often the switch sends keepalive
messages to its peer. The default is 60 seconds. The range is from 0 to 65535.
The elapsed time (in seconds) after not receiving a keepalive message that the
software declares a peer dead. The default is 180 seconds. The range is from 0
to 65535.
60 seconds
KEEPALIVE:
180 seconds
HOLDTIME:
Router configuration
The timers configured for a specific neighbor, or peer group, override the timers
configured for all BGP neighbors using the timers bgp command.
The following example shows how to configure the KEEP-ALIVE timer to 120
seconds and the HOLD-TIME timer to 360 seconds for the neighbor
172.16.10.10:
Verify the settings by entering the show ip bgp neighbor command.
neighbor timers
438