Qos Bandwidth - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

qos bandwidth

qos bandwidth {egress | ingress} NUMBER-KBPS
no qos bandwidth {egress | ingress}
Syntax Description
NUMBER-KBPS
Default
Command Mode
Usage Guideline
Example
Switch(config)#interface eth2.5
Switch(config-if)#qos bandwidth ingress 128
Switch(config-if)#qos bandwidth egress 256
CLI Reference Guide
To set the received bandwidth limit values for an interface, use the bandwidth
ingress command in interface configuration mode. To set the transmit bandwidth
limit values on an interface use the bandwidth egress command in interface
configuration mode. To disable bandwidth limit, use the no form of this command.
Specifies the number of kilo bytes per second as the limitation on the bandwidth.
min: 0KB to max:10MB per second
Disabled
Interface configuration
Only physical ports are valid for this command.
The specified limitation should not exceed the maximum speed of the specified
interface.
For ingress bandwidth limitation, the ingress will send pause frame or flow control
frame when the received traffic exceeds the limitation.
In the following example, bandwidth limitations are configured on eth 2.5. The
ingress bandwidth is limited to 128 Kbps and the egress bandwidth is limited to
256 Kbps.
Verify the settings by entering the show qos interface bandwidth command.
qos bandwidth
490