DGS-6604
m
Switch#telnet 10.74.19.2
Connecting to 10.74.19.2 ...
Could not open connection to the host, on port 23: Network is unreachable
Switch#
Switch#configure terminal
Switch(config)#mgmt-if
Switch(mgmt-if)#telnet 20.74.19.200
Connecting to 20.74.19.200 ...
Connected to 20.74.19.200.
Escape character is 'Ctrl-_'.
Telnet connecting ...
Copyright (c) 2010 D-Link Corporation. All rights reserved.
Switch>
Supported commands are:
e -
If other key is pressed, the terminal will return to the original active
Telnet session.
The telnet is disconnected.
Switch(mgmt-if)
CLI Reference Guide
The following example shows a telnet session attempting to connect to IP
address 10.74.19.2, but the IP adress is not reachable.
The following example shows how to enter the management interface mode and
telnet to the IP address 20.74.19.200 with default port 23. Then the example
shows how to exit the telnet session by entering the escape sequence : Ctrl-_
and then followed by the 'e' key.
Chassis-based High-Speed Switch
Command Line Interface
Firmware: 1.00.029
terminate the current Telnet session
telnet
875