Show Ip Arp Inspection - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

show ip arp inspection

show ip arp inspection [interfaces [PORT [, | -]] | statistics VLAN [, | -]]
Syntax
interfaces PORT
,
-
statistics VLAN
Default
Command Mode
Usage Guideline
Example
Switch# show ip arp inspection statistics vlan 10
VLAN Forwarded
----- ---------
10
VLAN DHCP Permits
----- ------------
10
VLAN Dest MAC Failures
----- -----------------
10
Switch#
CLI Reference Guide
Use this command to display the status of DAI for a specific range of VLANs.
Specifies a port, range of ports or all ports to configure.
(Optional) Specify a series of interfaces, or separate a range of interfaces from a
previous range. No space before and after the comma.
(Optional) Specify a range of interfaces. No space before and after the hyphen.
(Optional) Specified a VLAN or range of VLANs.
Not applicable
EXEC mode or any configuration mode.
If you do not enter the statistics keyword, the configuration and operating state
of DAI for the selected range of VLANs is displayed. If you do not specify the
interface name, the trust state for all applicable interfaces in the system are
displayed.
This example shows how to display the statistics of packets that have been
processed by DAI for VLAN 10:
Dropped
-----------
21546 145261
Source MAC Failures
-------------------
21546
IP Validation Failures
----------------------
0
DHCP Drops
----------
145261
0
0
show ip arp inspection
786