Ipv6 Nd Prefix - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604

ipv6 nd prefix

ipv6 nd prefix X:X::X:X/M <0-4294967295> <0-4294967295> [off-link | no-autoconfig]
no ipv6 nd prefix X:X::X:X/M
Syntax Description
X:X::X:X/M
<0-4294967295>
<0-4294967295>
off-link
no-autoconfig
Default
Command Mode
Usage Guideline
Example
Switch > enable
Switch # configure terminal
Switch (config) # interface vlan1
Switch (config-if) # ipv6 nd prefix 3ffe:501:ffff:100::/64 30000 20000
Switch (config-if) #
CLI Reference Guide
This command is used to add or modify IPv6 prefix information to RA (router
advertisement) for an interface of this switch. If the prefix already exists, then the
command modifies the parameter. The no form of the command removes it.
IPv6 network address. This argument must be in the form documented in
RFC2373 where the address is specified in hexadecimal format using a 16-bit
value between colons.
X:X::X:X: IPv6 address
M: IPv6 prefix length
Valid life time in seconds.
Preferred lifetime in seconds.
Turn off on-link flag.
Turn off autoconfig flag.
0-4294967295: 2592000
0-4294967295: 604800
off-link: On
no-autoconfig: On
VLAN interface configuration
The VLAN interface must be created first before this command can be used.
This example shows how to configure IPv6 prefix information incidence:
ipv6 nd prefix
334