D-Link DGS-6600-48T Cli Reference Manual page 829

DGS-6604 m
ssh
ssh [-c {3des | aes128-cbc | aes256-cbc}] [-m {hmac-md5 | hmac-sha1 | hmac-sha1-96}] [-p
PORT-NUMBER] -l USERNAME {IP-ADDRESS | IPV6-ADDRESS}
Syntax
-c {3des | aes128-cbc
| aes256-cbc}
-m {hmac-md5
hmac-sha1 | hmac-
sha1-96}
-p PORT-NUMBER
-l USERNAME
IP-ADDRESS
IPV6-ADDRESS
Default
Command Mode
Usage Guideline
Example
CLI Reference Guide
To start an encrypted session with a remote networking device, use the ssh
command in user EXEC mode.
(Optional)Specifies the crypto algorithm, 3DES, AES128-CBC or AES256-CBC, to
use for encrypting data.
If you do not specify the -c keyword, during negotiation the remote networking device
sends all the supported crypto algorithms.
(Optional)Specifies a Hashed Message Authentication Code (HMAC) algorithm,
|
HMAC-MD5, HMAC-SHA1 or HMAC-SHA1-96.
If you do not specify the -m keyword, during negotiation the remote networking device
sends all the supported crypto algorithms.
(Optional) The TCP port number. TCP ports are numbered between 1 and 65535.
The "well-known" TCP port for the SSH protocol is 22.
Specifies the USERNAME to use when logging in as on the remote networking
device running the SSH server.
IPv4 address of the host.
IPv6 address of the host.
None
Management interface mode or User EXEC mode.
The ssh command enables a device to make a secure, encrypted connection to
another device running an SSH Version 2 server. This connection provides
functionality that is similar to that of an outbound Telnet connection except that
the connection is encrypted. With authentication and encryption, the SSH client
allows for a secure communication over an insecure network.
ssh command is allowed under both management interface mode and User
EXEC mode. For User EXEC mode, the outgoing physical interfaces does not
include management interface. If you are going to use ssh to login a device
which can be reached only via the management port, you should use ssh
command under management interface mode by entering mgmt-if command
first.
The following example shows how to ssh to the ip address 20.74.19.200 with
default port 22 (optional port parameter is provided). The ip address of
20.74.19.200 is management interface which allows user to long in.
ssh
819