Ipv6 Rip Split-Horizon - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604

ipv6 rip split-horizon

ipv6 rip split-horizon
no ipv6 rip split-horizon
Syntax
Default
Command Mode
Usage Guideline
Example
Switch > enable
Switch # configure terminal
Switch (config)# interface vlan1
Switch (config-if)# ipv6 rip split-horizon
CLI Reference Guide
To enable IPv6 RIP split-horizon mechanism, use the ipv6 rip split-horizon
command. To disable the split horizon processing of IPv6 RIP updates, use the
no form of this command.
None
This command is disabled by default.
Interface configuration
This command configures split horizon processing of IPv6 RIP router updates. If
split horizon is configured on interfaces where the networks are learned, then the
advertisement of networks sent out from those same interfaces is suppressed.
When both split horizon and poison reverse are configured, then split horizon
behavior is replaced by poison reverse behavior routes. The poison reverse
behavior routes are learned via RIP and are advertised out the interface over
which they were learned. They are advertised with an unreachable metric.
The following example configures split horizon processing for the IPv6 RIP
routing process.
ipv6 rip split-horizon
349