Show Ip Pim Rp Mapping - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

show ip pim rp mapping

show ip pim rp mapping
Syntax
Default
Command Mode
Usage Guideline
Example
Switch#show ip pim
PIM Group-to-RP Mappings
Group(s): 224.0.0.0/4
RP: 90.1.1.3
Info source: 90.1.1.3, via bootstrap, priority 0
Uptime: 0DT16H52M39S, expires: 0DT0H2M50S
Display Field
Descriptions
Field
RP
Info source
Via bootstrap
Priority
Uptime
Expires
CLI Reference Guide
Use this command to show group-to-RP (rendezvous point) mappings, and the
RP set.
None
None
User EXEC or any configuration mode
Use this command to display active rendezvous points (RPs) that are cached
with associated multicast routing entries.
This command is used to display the RP mapping information viewed by the
router
The following is sample output from the show ip pim rp mapping command with
the group address 239.1.1.1 specified:
rp mapping
The table below shows the ip pim rp mapping detailed field descriptions.
Descriptions
Address of the RP for the group specified.
Indicates from which system the router learned this RP information. RP was
selected by the bootstrap mechanism. In this case, the BSR is also the RP.
The RP mapping information is learned from RP.
The RP priority
Length of time that the router has known about this RP.
Time after which the information about this RP expires. If the router does not
receive any refresh messages in this time, it will discard information about this
RP.
show ip pim rp mapping
668