Toro Greensmaster eFlex 1021 Service Manual page 58

Installing the Reel Drive Assembly
g312504
1. Retaining ring must be fully seated
Traction and Reel Drive Systems: Service and Repairs
Note: Refer to Figure 15
1. Use a press to install the 4 ball bearings (items 2 and 5 in
reel drive housing (6).
2. Secure the ball bearings with 2 retaining rings (item 3 and 4 in
into the reel drive housing (6).
3. Install the bearing shield (11) into the reel drive housing (25).
Note: Make sure that the carpet side of the bearing shield (11) is facing
towards the bearing.
4. Slide the reel shaft driver (13) into the reel drive housing (25).
5. Slide the spacer (9) into the reel drive housing (25).
6. Install the hipro key (12) onto the reel shaft driver (13). Apply anti-seize
lubricant on top of the key.
7. Install the reel pulley (8) onto the reel shaft driver (13). Secure the reel pulley
(8) with the lock nut (7).
8. Torque tighten the lock nut to 36.6 to 44.7 N∙m (27 to 33 ft-lb).
9. If removed, apply a coat of grease to the new O-ring (20) and install onto
the pivot sleeve.
10. Pack the internal splines of the reel shaft driven (22) with grease. Slide the
reel shaft driven (22) into the reel drive housing (25).
11. Slide the spacer (9) into the reel drive housing (25).
12. Install the hipro key (12) onto the reel shaft driven (22). Apply anti-seize
lubricant on top of the key.
13. Install the reel pulley (27) onto the reel shaft driven (22). Secure the reel
pulley (27) with the lock nut (7).
14. Torque tighten the lock nut to 36.6 to 44.7 N∙m (27 to 33 ft-lb).
15. If removed, install the bushing (29) into the idler arm (28).
16. If removed, use a press to install the 2 ball bearings (5) onto the idler arm
(28) and secure the ball bearings with a retaining ring (4).
17. Install and secure the idler am (28) into the reel drive housing (25) with
socket head screw (30) and nut (23).
18. Install the carriage bolt (6), washer (24) and nut (18) to the idler arm (28) and
reel drive housing (25). Do not tighten the nut (18).
19. Place the V-ring seal (21) into the reel drive housing (25).
20. Attach a new gasket (3) onto the reel drive housing (25).
during the procedure.
Figure 17
2. Press sleeve to shoulder
Page 4–10
Figure 16) into the
Figure 16)
Greensmaster ® eFlex 1021
20248SL Rev C