Toro Greensmaster eFlex 1021 Service Manual page 225

Disassembling the Height Adjuster
Assembling the Height Adjuster
Greensmaster ® eFlex 1021
20248SL Rev C
1. Ensure that the cutting-unit-drive lever is in the D
machine on a level surface, release the clutch bail, engage the service and
parking brake, rotate the key switch to O
the Operator's Manual.
2. Disconnect the battery; refer to
Battery Pack (page
3. Remove the cutting unit from the machine; refer to the Operator's Manual.
4. Remove the cotter pin and adjuster pin that secure the eye bolts to the lugs
of the groomer gearbox and the idler plate.
5. Loosen the lock screws that secure the front roller to the height-of-cut arms.
6. Remove the lock nuts, height of cut washers, and plow bolts that secure
the height-of-cut arms to the cutting unit side plates, and remove the arms
from the cutting unit.
7. If needed, remove the height-of-cut bolts from the groomer height of cut arms.
8. Disassemble the height adjuster assembly as necessary.
9. Clean all the components and inspect for wear or damage. Replace all the
worn or damaged components.
If the cutting unit is equipped with an eyebolt and flange nut used to
adjust the spring pretension for the height of groom adjuster, replace
the flange nut with washers to eliminate premature hardware wear.
1. Apply anti-seize lubricant to the upper threads of the eye bolts and lower
threads of the height-of-cut bolts.
2. Assemble an eye bolt to each of the height-of-cut arms with a serrated-flange
nut, washer 20.6 x 10.3 mm (0.813 x 0.406 inch), inner and outer springs,
and washer 20.6 x 14.3 mm (0.813 x 0.563 inch) washer below the slot in
the arms, and the quick up handle, quick up cover, and height adjuster knob
above the slots.
3. Apply anti-seize lubricant to the upper threads of the adjustment rod and
lower threads of the height adjusters. Assemble the height adjuster assembly.
4. Assemble the height-of-cut bolts to the height-of-cut arms.
5. If both the height of cut arms are removed, align 1 height-of-cut arm and
height-of-cut bolt to the cutting unit side plate.
6. Loosely assemble the height-of-cut arm to the side plate with the plow bolt,
plow bolt, height of cut washer, and lock nut. Do not tighten the flange lock
nut.
7. Loosely assemble the front roller shaft to the height-of-cut arm.
8. Assemble the other height of cut bracket to the front roller shaft. Assemble
height-of-cut arm and height-of-cut bolt to the cutting unit side plate.
9. Assemble the height-of-cut arm to the side plate with the plow bolt, plow
bolt, height of cut washer, and lock nut. Tighten the 2 lock nuts and 2 plow
bolts finger tight.
10. Adjust the height-of-cut bolts so that the height-of-cut arm are the same.
11. Center the front roller between the height-of-cut arms, and tighten the lock
screws in the height-of-cut arms.
FF
Disconnecting and Connecting the Lithium
5–3).
IMPORTANT
Page 8–27 Universal Groomer (Optional): Service and Repairs
position, park the
ISENGAGE
, and remove the key; refer to