Brake Latch Shaft - Toro Greensmaster eFlex 1021 Service Manual

Brake Latch Shaft

g336961
1. Shoulder bolt
2. Flange bushing (2 each)
3. Lever
4. Brake lock lever
Disassembling the Brake Latch Shaft
Controls, Wheels, and Accessories : Service and Repairs
5. Roll pin
6. Bolt
7. Flange bushing (2 each)
8. Flange nut
Note: Refer to Figure 83
1. Ensure that the cutting-unit-drive lever is in the D
machine on a level surface, release the clutch bail, engage the service and
parking brake, rotate the key switch to O
the Operator's Manual.
2. Disconnect the battery pack; refer to
Lithium Battery Pack (page
3. Remove the bolts and washers that secures the control covers to the upper
receiver weldment.
4. Using the drift pin, remove the roll pin (5) from the brake lock lever (4).
5. Slide and remove the brake lock lever (4) from the brake latch shaft (9).
Figure 83
10.
11.
12.
during this procedure.
FF
Disconnecting and Connecting the
5–3).
Page 6–12
9. Brake latch shaft
Torsion spring
Flange nut
Upper receiver weldment
position, park the
ISENGAGE
, and remove the key; refer to
Greensmaster
20248SL Rev C
® eFlex 1021