Toro Greensmaster eFlex 1021 Service Manual page 190

Installing the Reel Assembly (continued)
DPA Cutting Units: Service and Repairs
g323557
1. RH reel nut
2. Reel shaft
A. Insert a long- handled pry bar (3/8 x 12 inch with a screwdriver handle
recommended) through the front of the cutting unit. The pry bar should
pass between the top of the reel shaft and the backs of the reel blades so
that the reel will not move; refer to
To avoid grinding the reel, do not contact the cutting edge of
any blade with the pry bar as this may damage the cutting edge
and/or cause a high blade.
B. Move the pry bar against the weld side of the reel support plate closest to
the reel nut being tightened.
The reel nut on the left end of the cutting reel has left- hand
threads. The reel nut on the right end of the cutting reel has right-
hand threads.
C. Rest the handle of the pry bar against the front roller and tighten the reel
nut from 123 to 149 N·m (90 to 110 ft-lb).
D. Position the pry bar in the same manner on the opposite end of the reel
and tighten the other reel nut from 123 to 149 N·m (90 to 110 ft-lb).
10. Check to make sure the rear roller and cutting reel are parallel; refer to
Leveling the Rear Roller (page
11. Install the reel drive assembly; refer to
(page 4–10). Grease the splines with high temp Mobil XHP−222 grease
or equivalent.
12. Install the cutting unit assembly to the machine; refer to the traction unit
Operator's Manual.
Figure 113
3. Support plate, weld side
4. Pry bar
Figure
IMPORTANT
IMPORTANT
7–4).
Installing the Reel Drive Assembly
Page 7–24
113.
Greensmaster ®
20248SL Rev C
eFlex 1021