Toro Greensmaster eFlex 1021 Service Manual page 185

Removing the Reel Assembly (continued)
Greensmaster ® eFlex 1021
20248SL Rev C
parking brake, rotate the key switch to O
the Operator's Manual.
2. Disconnect the battery pack; refer to
Lithium Battery Pack (page
3. Remove the cutting unit assembly from the machine; refer to the traction
unit Operator's Manual.
4. If the cutting unit is equipped with an optional groomer, remove the groomer
gear box; refer to Removing the Gearbox Assembly (page
5. Remove the reel drive assembly; refer to
(page 4–7).
6. Remove the fasteners securing the counterweight (24) and gasket (23) to the
RH side plate. Remove the counterweight and discard the gasket.
Contact with the reel, bedknife or other cutting unit parts can result
in personal injury. Use heavy gloves when removing the cutting reel.
If the reel bearings or seals are being replaced, the right and left reel
nuts must be removed. Use the following procedure to restrain the
reel and loosen the components before removing the roller.
7. Loosen the RH reel nut and LH reel nut.
A. Tip up the cutting unit to access the bottom of the reel.
g381385
1. Reel nut – RH
2. Reel shaft
B. Insert a long- handled pry bar (3/8 x 12 inch with screwdriver handle
recommended) through the bottom of the cutting unit. The pry bar should
pass between the top of the reel shaft and the backs of the reel blades so
that the reel will not move; refer to
FF
Disconnecting and Connecting the
5–3).
Removing the Reel Drive Assembly
CAUTION
IMPORTANT
Figure 110
3. Support plate, weld side
4. Pry bar
Figure
Page 7–19
, and remove the key; refer to
8–4).
110.
DPA Cutting Units: Service and Repairs