Bedknife - Toro Greensmaster eFlex 1021 Service Manual

Bedknife

Removing the Bedknife
Installing the Bedknife
DPA Cutting Units: Service and Repairs
g227001
1. Bedknife screw (13 used)
2. Bedknife
1. Remove the bedbar from the cutting unit; refer to
(page 7–7).
2. Using a socket wrench and the bedknife screw tool, remove screws that
secure the bedknife to the bedbar, and remove the bedknife; refer to
Tools (page 2–13).
Discard the old bedknife screws.
3. Refer to Grinding the Bedknife (page 7–14)
1. Use a scraper to remove all rust, scale, and corrosion from the bedbar
surface under the bedknife. Lightly oil the bedbar surface before installing
the bedknife.
2. Make sure that screw threads in bedbar (5/16-18UNC-2A) are clean.
Use new bedknife screws when installing the bedknife.
3. Assemble the bedknife to bedbar using new bedknife screws. Apply
anti-seize lubricant to the threads of new screws. Do not apply anti-seize
lubricant to the taper of the screw heads
4. Install all screws but do not tighten.
Do not use an impact wrench to tighten screws into the bedbar.
Figure 103
3. Bedbar
IMPORTANT
IMPORTANT
IMPORTANT
Page 7–12
Removing the Bedbar
for additional information.
Greensmaster
20248SL Rev C
Special
® eFlex 1021