Toro Greensmaster eFlex 1021 Service Manual page 215

Removing the Idler Assembly (continued)
Installing the Idler Assembly
Greensmaster ® eFlex 1021
20248SL Rev C
• Cutting units with a Single-Lug Groomer Gearbox: remove the shoulder
screw and hardened washer that secure the eye bolt to the spring pin
of the idler plate.
• Cutting units with a 2-Lug Groomer-Drive Gearbox: remove the cotter
pin and adjuster pin that secure the eye bolt to the spring pin of the idler
plate.
Note: Discard the cotter pin.
4. Remove the idler assembly.
5. If needed, remove the spring pin from the idler plate.
6. Inspect the shields, bearing, and bushing of the idler assembly. Replace
worn or damaged components.
1. If the shields, bearing, or bushing were removed from the idler plate, install
new components as follows:
A. Press the bushing into the idler plate until the bushing is centered in
the bore.
B. Press the bearing into the idler plate so that the bearing contacts the
shoulder in bore, and secure the bearing with the retaining ring.
C. Assemble the 2 bearing shields to the idler plate with flocked side of
shield toward the bearing.
D. Check the idler plate orientation (left side of the cutting unit), and insert
the stub shaft (item 12 in
the through hole in the shaft to prevent it from rotating, and torque the
flange nut to 37 to 45 N∙m (27 to 33 ft-lb).
E. If the spring pin was removed from the idler arm, install the spring pin,
and torque it to 37 to 45 N∙m (27 to 33 ft-lb).
2. Assemble the eye bolt of the groomer adjuster to the idler plate
131) as follows:
• Cutting Units with a Single-Lug Groomer Gearbox
A. Apply a coat of medium-duty thread-locking compound to the
shoulder screw.
B. Assemble the eye bolt to the spring pin of the idler plate with the
shoulder screw. Torque the shoulder screw to 16.3 to 20.3 N∙m
(12 to 15 ft-lb).
• Cutting units with a 2-Lug Groomer-Drive Gearbox: assemble the eye
bolt to spring pin of the idler plate with the adjuster pin and cotter pin.
Figure 130) through shields and bearing. Use
Page 8–17 Universal Groomer (Optional): Service and Repairs
(Figure