Toro Greensmaster eFlex 1021 Service Manual page 191

Installing the Reel Assembly (continued)
Preparing the Reel for Grinding
Greensmaster ® eFlex 1021
20248SL Rev C
13. Use a new gasket and install the counterweight to the right side plate with
the fasteners previously removed.
14. If the cutting unit is equipped with an optional groomer, install the groomer
gear box; refer to Installing the Gearbox Assembly (page
15. Adjust the cutting unit; refer to the cutting unit Operator's Manual.
A. Adjust the bedknife-to-reel contact.
B. Adjust the height-of-cut (rear roller height then front roller height).
C. Adjust the cut-off bar.
D. Adjust the optional groomer reel if equipped; refer to the universal
groomer Installation Instructions.
Reel Grinding Specifications
Reel Diameter New (D)
Reel Diameter Service Limit
Reel Diameter Taper Limit (D1 – D2)
Blade Land Width
Blade Relief Angle
Reel Shaft Diameter
g227307
Before grinding a cutting reel, make sure that all the cutting unit components
are in good condition. Depending on the type of grinder used, faulty cutting
128.5 mm (5.06 inch)
114.3 mm (4.50 inch)
0.25 mm (0.01 inch)
0.8 to 1.2 mm (0.03 to 0.05 inch)
30° ±2°
34.9 mm (1.375 inch)
Figure 114
(R = Direction of Rotation)
Page 7–25
8–13).
DPA Cutting Units: Service and Repairs