Toro Greensmaster eFlex 1021 Service Manual page 183

Checking the Bedknife on a Granite Surface Plate
Greensmaster ® eFlex 1021
20248SL Rev C
1. Place bedbar-bedknife assembly on a precision flat granite surface plate with
the cutting-edge down. Look for visible light between the granite and the
bedknife, or use a shim to test for .002 inch or greater gaps
g376005
1. Shim (.002 inch) to test for gaps
2. Inspect the surface between the bedknife
and granite for light
2. If there is a gap that the shim fits through, or light shows between the granite
and the cutting edge after grinding with 1 shim, regrind the bedknife with an
additional shim installed (maximum of 4 shims total, 2 per magnet); refer to
Troubleshooting Bedknife Grinding (page
Figure 108
3. Granite surface plate
7–16).
Page 7–17
(Figure 108).
DPA Cutting Units: Service and Repairs