Toro Greensmaster eFlex 1021 Service Manual page 221

Disassembling the Height Adjuster
Assembling the Height Adjuster
Greensmaster ® eFlex 1021
20248SL Rev C
Note: Refer to Figure 134
1. Ensure that the cutting-unit-drive lever is in the D
machine on a level surface, release the clutch bail, engage the service and
parking brake, rotate the key switch to O
the Operator's Manual.
2. Disconnect the battery; refer to
Battery Pack (page
3. Remove the cutting unit from the machine; refer to the Operator's Manual.
4. Remove the shoulder screws and hardened washers that secure the eye
bolts to the lugs of the groomer gearbox and the idler plate.
5. Loosen the lock screws that secure the front roller to the height-of-cut arms.
6. Remove the lock nuts, height of cut washers, and plow bolts that secure the
height-of-cut arms to the cutting unit side plates, and remove the height
adjusters and front roller from the cutting unit.
7. Remove the height-of-cut bolts from the groomer height of cut arms.
8. Disassemble the height adjuster assembly as necessary.
9. Clean all the components and inspect for wear or damage. Replace all the
worn or damaged components.
1. Apply anti-seize lubricant to the upper threads of the adjustment rod and
lower threads of the height adjusters.
2. Assemble the height-of-cut bolts to the height-of-cut arms.
3. If both the height of cut arms are removed, align 1 height-of-cut arm and
height-of-cut bolt to the cutting unit side plate.
4. Loosely assemble the height-of-cut arm to the side plate with the plow bolt,
plow bolt, height of cut washer, and lock nut. Do not tighten the flange lock
nut.
5. Loosely assemble the front roller shaft to the height-of-cut arm.
6. Assemble the other height of cut bracket to the front roller shaft. Assemble
height-of-cut arm and height-of-cut bolt to the cutting unit side plate.
7. Assemble the height-of-cut arm to the side plate with the plow bolt, plow
bolt, height of cut washer, and lock nut. Tighten the 2 lock nuts and 2 plow
bolts finger tight.
8. Adjust the height-of-cut bolts so that the height-of-cut arm are the same.
9. Center the front roller between the height-of-cut arms, and tighten the lock
screws in the height-of-cut arms.
10. Align the hardened washers between the eye bolts to the groomer gearbox
and idler arm lugs, and loosely assemble the eye bolts and washers to the
gearbox and idler plate lugs with the shoulder screws.
11. Adjust the cutting unit height-of-cut; refer to Cutting Unit Operators Manual.
12. Adjust the groomer reel height; refer to Universal Groomer Drive Kit
Installation Instructions.
13. Ensure that both groomer quick up handles are in the O
during this procedure.
FF
Disconnecting and Connecting the Lithium
5–3).
Page 8–23 Universal Groomer (Optional): Service and Repairs
position, park the
ISENGAGE
, and remove the key; refer to
PERATING
position.