Servicing The Bedbar Adjuster - Toro Greensmaster eFlex 1021 Service Manual

Servicing the Bedbar Adjuster

Removing the Bedbar Adjuster
g312976
1. Bedbar adjuster shaft (2 each)
2. Keyed flanged bushing (4 each)
3. Detent (2 each)
4. Bolt (2 each)
DPA Cutting Units: Service and Repairs
5. Wave washer (2 each)
6. Retaining ring (2 each)
7. Bedbar adjuster screw (2 each)
8. Bedbar assembly
Note: Refer to Figure 102
1. Remove bedbar; refer to
2. Remove the lock nut (11), compression spring (10) and washer (9) from the
bedbar adjuster screw (7).
Note: The bedbar adjuster shaft (1) has left-hand threads.
3. Unscrew the bedbar adjuster shaft (1) from the bedbar adjuster screw (7).
4. Remove the retaining ring (6) and wave washer (5) from the adjuster shaft
(7) and remove the adjuster shaft.
5. Inspect the flange bushings (2) in the cutting unit side plate (12) and replace
them if necessary.
6. Inspect the detent (3) and replace it if necessary.
Figure 102
10.
11.
12.
during this procedure.
Removing the Bedbar (page
Page 7–10
9. Washer (2 each)
Compression spring
Nut (2 each)
Side plate
7–7).
Greensmaster
20248SL Rev C
® eFlex 1021